Fujitsu PRIMERGY TX100 S3 - Configuring the server

TX100 S3 Upgrade and Maintenance Manual 59
Basic hardware procedures
4.5 Connecting the server to the mains
The PRIMERGY TX100 S3 server is equipped with a standard power supply
unit that automatically adjusts to any mains voltage in the range of 100 VAC to
240 VAC.
V CAUTION!
The power supply automatically adjusts to any mains voltage in the
range of 100 VAC to 240 VAC. You may only operate the server if its
rated voltage range corresponds to the local mains voltage.
Ê Connect the power cord to the power supply unit.
Ê Connect the mains plug to a grounded mains outlet in the in-house power
supply network.
Securing power cord
Figure 17: Securing the power cord
Ê Loop the cable past the cable tie mounting bracket as shown.
/
0