206 Upgrade and Maintenance Manual TX100 S3
Main memory
Figure 124: Installing memory modules (C)
Ê Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
10.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section "Installing the side cover" on
page 58.
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section "Connecting the server to the mains" on
page 59.
Ê If available, update the system board BIOS to the latest version as described
in section "Updating the system board BIOS" on page 73.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 82.
To Next Page
Loading...
