Field Description
• %: The VDSL interface is not active.
• +- +': ETSI T1.413
• 01-2 :ADSL1 / G.DMT is used.
• 01-2 0: The ADSL mode is automatically adapted
for the remote terminal.
• 01-2: ADSL2 / G.992.3 is used.
• 01-2 /&: ADSL2 Plus / G.992.5 is used.
• 81-2 (default value): VDSL is used.
• 81-2701-2 (/: VDSL/ADSL multi mode is used.
Transmit Shaping Select whether the data rate in the send direction is to be re-
duced. This is only needed in a few cases for special DSLAMs.
Possible values:
• 1/ 2 -," (Line Speed) The data rate in the
send direction is not reduced.
• #,&to #,&: The data rate in the send dir-
ection is reduced to a maximum of 128,000 bps to 2,048,000
bps in defined steps.
• 3&!: The data rate is reduced to the value
entered in Maximum Upstream Bandwidth
The default value is Default (Line Speed).
Maximum Upstream
Bandwidth
Only for Transmit Shaping = 3&!
Enter the maximum data rate in the send direction in bits per
second.
Funkwerk Enterprise Communications GmbH
11 Physical Interfaces
bintec Rxxx2/RTxxx2 147
To Next Page
Loading...