Funkwerk R1202 - Page 221

Field Description
Select the type.
Possible values: 0), % ,/), 1& %!
#/, -% F%, ;%, %, + =%,
+&,, +&, ,/).
See RFC 792.
The default value is 0).
Connection State With Protocol = +4, you can define a filter that takes the
status of the TCP connections into account.
Possible values:
• &#/&: All TCP packets that would not open any new
TCP connection on routing over the gateway match the filter.
• 0) (default value): All TCP packets match the filter.
Destination IP Ad-
dress/Netmask
Enter the destination IP address of the data packets and the
corresponding netmask.
Destination Port/Range Only for Protocol = +4 or 31
Enter a destination port number or a range of destination port
numbers.
Possible values:
• !0//! (default value): The destination port is not specified.
• -,%) ,: Enter a destination port.
• -,%) , $: Enter a destination port range.
Source IP Address/
Netmask
Enter the source IP address of the data packets and the corres-
ponding netmask.
Source Port/Range
Only for Protocol = +4 or 31
Enter a source port number or a range of source port numbers.
Possible values:
• !0//! (default value): The destination port is not specified.
• -,%) ,: Enter a destination port.
• -,%) , $: Enter a destination port range.
Funkwerk Enterprise Communications GmbH
14 Networking
bintec Rxxx2/RTxxx2 207