Field Description
Description Enter a name for uniquely identifying the connection partner.
The first character in this field must not be a number No special
characters or umlauts must be used.
Connection Type Select which layer 1 protocol your device should use.
This setting applies for outgoing connections to the connection
partner and only for incoming connections from the connection
partner if they could be identified on the basis of the calling
party number.
Possible values:
• -1* #,&: For 64-kbps ISDN data connections.
• -1* #,&: For 56-kbps ISDN data connections.
User Name Enter your device code (local PPP user name).
Remote User (for Dial-
in only)
Enter the code of the remote terminal (remote PPP user name).
Password Enter the password.
Always on Select whether the interface should always be activated.
The function is enabled with #/.
The function is disabled by default.
Only activate this option if you have Internet access with a flat-
rate charge.
Connection Idle
Timeout
Enter the idle time in seconds for static short hold. The static
short hold setting determines how many seconds should pass
between sending the last traffic data packet and clearing the
connection.
Possible values are ! to ' (seconds). A value of ! means
that the connection is set up again immediately after disconnec-
tion and deactivates short hold. The default value is .
Fields in the IP Mode and Routes menu
Funkwerk Enterprise Communications GmbH
17 WAN
bintec Rxxx2/RTxxx2 279
To Next Page
Loading...