Field Description
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• -% (default value): You enter a static IP address.
• 0&&: Your device dynamically assigns an
IP address to the remote terminal.
• 0&&: Your device is dynamically assigned an
IP address.
Default Route Only if IP Address Mode = -%
and 0&&
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with #/.
The function is disabled by default.
Create NAT Policy Only if IP Address Mode = -%
and 0&&
When you configure an ISDN Internet connection, specify
whether Network Address Translation (NAT) is to be activated.
The function is enabled with #/.
The function is disabled by default.
Local IP Address Only if IP Address Mode = -%
Assign the IP address from your LAN to the ISDN interface
which is to be used as your device's internal source address.
Route Entries Only if IP Address Mode = -%
Define other routing entries for this connection partner.
• ; 0&&: IP address of the destination host or
network.
• *&: Netmask for Remote IP Address If no entry is
17 WAN Funkwerk Enterprise Communications GmbH
280 bintec Rxxx2/RTxxx2
To Next Page
Loading...