Fields in the ATM Profiles Parameter menu
Field Description
Provider Select one of the preconfigured ATM profiles for your provider
from the list or manually define the profile using !! 3&!
!!.
Description Only for Provider = !! 3&! !!
Enter the desired description for the connection.
ATM Interface Only if several ATM interfaces are available, e.g. if several inter-
faces are separately configured in devices with SHDSL.
Select the ATM interface that you wish to use for the connec-
tion.
Type Only for Provider = !! 3&! !!
Select the protocol for the ATM connection.
Possible values:
• 0+( (default value): Ethernet over ATM
(EthoA) is used for the ATM connection (Permanent Virtual
Circuit, PVC).
• ; %/& 0+(: Routed Protocols over
ATM (RPoA) is used for the ATM connection (Permanent Vir-
tual Circuit, PVC).
• 0+(: PPP over ATM (PPPoA) is used for the ATM
connection (Permanent Virtual Circuit, PVC).
Virtual Path Identifier
(VPI)
Only for Provider = !! 3&! !!
Enter the VPI value of the ATM connection. The VPI is the iden-
tification number of the virtual path to be used. Note your pro-
vider's instructions.
Possible values are to .
The default value is .
Virtual Channel Identi-
fier (VCI)
Only for Provider = !! 3&! !!
Enter the VCI value of the ATM connection. The VCI is the iden-
Funkwerk Enterprise Communications GmbH
17 WAN
bintec Rxxx2/RTxxx2 295
To Next Page