Field Description
Loopback End-to-End Select whether you activate the loopback test for the connection
between the endpoints of the VCC or VPC.
The function is enabled with #/.
The function is disabled by default.
End-to-End Send Inter-
val
Only if Loopback End-to-End is enabled.
Enter the time in seconds after which a loopback cell is to be
sent.
Possible values are to .
The default value is 5.
End-to-End Pending
Requests
Only if Loopback End-to-End is enabled.
Enter the number of directly consecutive loopback cells that
may fail to materialise before the connection is regarded as in-
terrupted ("down"). Possible values are to .
The default value is .
Loopback Segment Select whether you want to activate the loopback test for the
segment connection (segment = connection of the local end-
point to the next connection point) of the VCC or VPC.
The function is enabled with #/.
The function is disabled by default.
Segment Send Interval Only if Loopback Segment is enabled.
Enter the time in seconds after which a loopback cell is sent.
Possible values are to .
The default value is .
Segment Pending Re-
quests
Only if Loopback Segment is enabled.
Enter the number of directly consecutive loopback cells that
may fail to materialise before the connection is regarded as in-
terrupted ("down").
Funkwerk Enterprise Communications GmbH
17 WAN
bintec Rxxx2/RTxxx2 303
To Next Page