Field Description
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• -% (default value): You enter a static IP address.
• 0&&: Only for PPTP Mode = *-Your
device dynamically assigns an IP address to the remote ter-
minal.
• 0&&: Only for PPTP Mode = :& 4/!
( Your device is dynamically assigned an IP ad-
dress.
Default Route Only if IP Address Mode = -%
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with #/.
The function is disabled by default.
Create NAT Policy
Only if IP Address Mode = -%
When you configure an ISDN connection, specify whether Net-
work Address Translation (NAT) is to be enabled.
The function is enabled with #/.
The function is disabled by default.
Local IP Address Only for IP Address Mode = -%
Assign the IP address from your LAN to the ISDN interface
which is to be used as your device's internal source address.
Route Entries
Only if IP Address Mode = -%
Define routing entries for this connection partner.
• ; 0&&: IP address of the destination host or
LAN.
• *&: Netmask for Remote IP Address
• (%: The lower the value, the higher the priority of the
route (possible values ). The default value is .
Funkwerk Enterprise Communications GmbH
18 VPN
bintec Rxxx2/RTxxx2 357
To Next Page
Loading...