Field Description
IP Assignment Pool
(IPCP)
Only if IP Address Mode = 0&&
Select IP pools configured in the WAN->Internet + Dialup->IP
Poolsmenu. If an IP pool has not been configured here yet, the
message * ) appears in this field.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
Field Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed.
The default value is '.
Authentication
Select the authentication protocol for this PPTP partner.
Possible values:
• 0: Only run PAP (PPP Password Authentication Protocol);
the password is transferred unencrypted.
• 4@0 Only run CHAP (PPP Challenge Handshake Authentic-
ation Protocol as per RFC 1994); password is transferred en-
crypted.
• 074@0: Primarily run CHAP, otherwise PAP.
• (-!4@0: Only run MS-CHAP version 1 (PPP Microsoft
Challenge Handshake Authentication Protocol).
• 074@07(-!4@0: Give priority to CHAP, if refused use
the authentication protocol requested by the PPTP partner.
(MSCHAP version 1 or 2 possible.)
• (-!4@0 (default value): Run MS-CHAP version 2 only.
• *: Some providers use no authentication. In this case, se-
lect this option.
Encryption
If necessary, select the type of encryption that should be used
for data traffic to the connection partner. If Encryption is set,
the remote terminal must also support it, otherwise a connection
cannot be set up.
Possible values:
18 VPN Funkwerk Enterprise Communications GmbH
358 bintec Rxxx2/RTxxx2
To Next Page
Loading...