ENGLISH Use e Maintenance
1.3 IDENTIFICATION
Each individual machine has an identification plate (Fig.
1.2),indicating the following details:
1. Mark and address of the Manufacturer
2. Type and model of machine
3. Unloaded mass, in Kilograms
4. Mass full load, in Kilograms
5. Registration of the machine
6. Year of manufacture
7. Place of manufacture
You are advised to note down your data on the
form below, along with the date of purchase (8) and
the dealer’s name (9).
8. ..........................................................................
9. ..........................................................................
This information must always be quoted whenever as-
sistance or spare parts are needed.
ATTENTION!
Do not remove, tamper with or make the CE mark
affixed on the machine illegible.
Refer to the information provided on the CE mark for
the manufacturer’s contact details (e.g. for requesting
spare parts, etc.).
When the machine is demolished, destroy the
CE marking.
Figure 1.2: Identification plate
10- EN Cod. F07011577
To Next Page
Loading...
