Use e Maintenance ENGLISH
Figure 5.5: Drive hub position
3. Turn the drive hub 90
◦
to bring it to position (B) and
repeat the check described above.
4. If necessary, loosen the drive unit fastening screws
and reposition them properly. This adjustment op-
eration must be done at an authorised workshop.
5.9 CHECKING THE ELECTRI-
CAL SYSTEM
Always make sure the road lights work properly. Replace
any burned out bulbs or broken headlights.
Thoroughly check the electrical and electronic system.
In particular, all the electrical cables and boxes must be
intact and perfectly insulated.
Replace any damaged parts immediately.
Keep the electrical system clean and do not allow dust
to build up.
5.10 ELECTRONIC CONTROL
SYSTEM
For all the instructions regarding electronic control system
operation, refer to the specific manual.
Cod. F07011577 EN - 43
To Next Page
Loading...
