Chapter 4
RULES OF USE
To obtain the best performance from the equipment,
carefully follow what is set up below.
ATTENTION!
All maintenance work, adjustments and prepa-
ration for operation, must be carried out with the
power take-off of the tractor disconnected, the
machine on the ground on its supporting feet, the
tractor not running, the wheels blocked and the
key turned off.
4.1 ATTACHMENT THE TRAC-
TOR
The machine may be attached to any tractor fitted out with
a threepoint universal joint.
DANGER!
The attachment to the tractor is a very danger-
ous phase. Be sure to follow the instructions
carefully throughout the operation.
4.1.1 Hooking
The correct tractor/machine position, is determined by
placing the equipment at a distance from the tractor so
that the cardan joint remains extended by 5-10 cm from its
maximum closing position.
At this point, proceed as follows:
1. Hook the lifter bars onto the pins provided (1, Fig. 4.1
- 4.2). Block with the snap split pins. Hook the chains
to the lifting bars.
Figure 4.1: Lower linkages
Figure 4.2: Tie rods
Figure 4.3: Inserting the shaft
2. Hook the upper third point (2, Fig.4.2); the pin must
be locked with the specific split pin; using the adjust-
21
To Next Page
Loading...
