ENGLISH Use e Maintenance
Figure 2.1: Safety warning devices
The Manufacturer declines all liability should the safety pictograms supplied along with
the machine be missing, illegible or moved from their original position.
• AUTHORIZED SERVICE CENTER: The authorized
Service Center is a structure legally authorized by
the manufacturer which disposes of personnel spe-
cialized and qualified to carry out all the operations of
assistance, maintenance and repair - even of a cer-
tain complexity - found necessary to keep the ma-
chine in perfect working order.
Carefully read all the instructions before using the
machine; if in doubt, contact the technicians of the
Manufacturer’s dealer. The manufacturer declines all
responsibility for the non-observance of the safety
and accident prevention regulations described below.
General norms
1. Pay close attention to the danger signs in this manual
and on the machine.
2. The labels with the instructions attached to the ma-
chine give abbreviated advice for avoiding accidents.
3. Scrupulously observe, with the help of the instruc-
tions, the safety and accident prevention regulations.
4. Avoid touching the moving parts in any way whatso-
ever.
5. Any work on and adjustment to the machine must al-
ways be done with the engine switched off and the
tractor blocked.
6. People or animals must not, under any circumstances
be transported on the equipment.
7. It is strictly prohibited to drive the tractor, or allow it
to be driven, with the equipment attached by persons
not in possession of a driver’s license, inexpert or in
poor conditions of health.
8. Before starting the tractor and the equipment, check
that all safety devices for transport and use are in per-
fect working order.
9. Before starting up the equipment, check the area sur-
rounding the machine to ensure that there are no
people, especially children or pets, nearby, and en-
sure that you have excellent visibility.
10. Use suitable clothing. Avoid loose clothing or gar-
ments with parts that could in any way get caught in
the rotating or moving parts of the machine.
11. Before starting work, familiarize yourself with the con-
trol devices and their functions.
12. Only start working with the equipment if all the pro-
tective devices are in perfect condition, installed and
12- EN Cod. F07011577
To Next Page
Loading...
