GE Giraffe OmniBed Carestation CS1 - FIGURE 7-10. North Seal Parts; FIGURE 7-11. Beveled Side of North Spacer Toward Canopy

Chapter 7: Repair Procedures
Canopy Removal for Service
7-8 Service Manual
h. Install and remove seals to check for easy installation.
* You may wish to retain the hardware by sliding the seal over the rail. Then you can place the spacer washers on that
rail assembly before placing the rail assembly on the canopy.
10. Install north seal parts on the upside-down canopy:
a. Orient the north spacer with the beveled side toward the canopy edge, as shown in Figure 7-10
and Figure 7-11.
FIGURE 7-10. North Seal Parts
Beveled edge
INSIDE OF CANOPY
Smooth nut
Canopy
North seal
Spacer washer
M4x30 sockethead
set screw cup point
Hex socket end
OUTSIDE OF CANOPY
North spacer
FIGURE 7-11. Beveled Side of North Spacer Toward Canopy
Smooth nut
INSIDE OF CANOPY
Canopy
Spacer washer
Beveled edge
North spacer
Set screw
Hex socket end
OUTSIDE OF CANOPY