GE Vivid i User Manual

Measurement and Analysis
Vivid i User’s Manual 115
2378958-100 Rev. 02
Post-measurement assignment labels
Each type of measurement, within each mode, can be
associated with a set of pre-defined parameter labels.
Parameter labels can be assigned to the highlighted
measurement by the user.
To assign a parameter label to a
measurement:
1. Trackball to the actual measurement in the Measurement
result table (see Figure 6-4).
The selection of a
measurement with-
out pre-defined la-
bels will not display
the Parameter la-
bel menu.
2. Press SET.
A Parameter label menu is displayed.
3. Trackball through the Parameter label menu to highlight the
required label.
4. Press
SET to assign the highlighted parameter label to the
measurement.
The assigned measurements may be reviewed in the
Worksheet (see page 147). Up to five assigned measurements
with the same label can be stored in the patient archive.
CAUTION
Only assigned measurements will be saved. Measurements
without assignment will be lost when scanning is resumed.

GE Vivid i Specifications

General

Type	Portable Ultrasound System
Transducer Ports	2 active ports
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Imaging Modes	2D, M-Mode
Connectivity	DICOM, Ethernet, USB
Applications	Vascular, Abdominal
Weight	Approximately 5.5 kg (12.1 lbs)
Battery Life	Up to 1 hour (depending on usage)
Probes	Phased array, Linear array, Convex array