Getting started
18 Vivid i User’s Manual
2378958-100 Rev. 02
Switching On/Off
To switch on the unit:
1. Make sure a charge battery is in place by checking the
power indicator LED, or connect the appropriate AC power
supply adapter output to the rear of the unit (see
Figure 1-3).
2. Press (on/off button) on the top right of the control panel
(see Figure 1-6).
After initialization the default scanning screen (2D mode) is
displayed, using the active probe.
If the battery is too weak, an appropriate message will
display on screen accordingly.
Note: When turn-
ing ON a system
while system is in
standby, it takes a
few seconds before it
responds. Do not
push the on/off but-
ton again during
this period (A sec-
ond push will ini-
tiate a full
shutdown).
When used with the AC Power Adaptor, the system can be
used regardless of the battery level. The battery is
automatically charged when the system is operating with
the AC Power Adaptor.
LEDs
There are two LEDs to indicate the status of the system.
Password Protection
Log In
During the turn-on process the system may require the user to
enter a password in order to operate it. Personal IDs and
associated passwords can be configured in the Vivid i. See
"Presets and System setup" on page 283 for more information.
If IDs and passwords have been entered and the Use Auto
Logon is Off (see "Users" on page 331 for details), the
Operator Login Window appears, requesting for an ID and
• LED #1 Indicates power status.
After pressing the On/Standby switch, the system
power is ON and this LED is lit.
Color: Green
• LED #2 Indicates battery status.
When the battery is charged, the LED is green.
When the battery power is low, the LED is orange.
Color: Green and Orange
To Purchase, Visit Avobus.com or call 1-800-674-3655
To Next Page
Loading...
