Getting started
Vivid i User’s Manual 19
2378958-100 Rev. 02
password when Power up sequence is completed, or when it is
required.
Figure 1-4: Operator Login Window
Switching off the unit
When the Vivid i is switched off, the system performs an
automatic shutdown sequence. The unit can be switched off
into two states.
• Standby mode: most of the system is powered down, but
a certain portion of the unit remains energized. The standby
mode allows a shorter reboot time when the system is used
on a daily basis or moved from one place to another.
• Full shutdown: the entire system is shut down. Full
shutdown is recommended if the system is not intended to
be used for a whole day or longer. It is recommended to
perform a full shutdown at least once a week.
Full shutdown
After switching off
the system, wait at
least ten seconds be-
fore turning it on
again.
1. Press (on/off button) on the top left of the control panel.
The Exit dialogue window is displayed.
1. Operator:
2. Password
3. Emergency
4. Log on:
5. Cancel
Select the relevant Operator name.
Enter the Operator’s password.
Data stored for the duration of the current examination only.
Select type of Log on (for example, Standard logon).
Cancel Log on.
To Next Page
Loading...
