Presets and System setup
326 Vivid i User’s Manual
2378958-100 Rev. 02
TCP/IP
This configuration category enables the user with
administration rights to set the Transmission Protocol/Internet
Protocol for the system and connected remote archive.
Figure 12-19: The sublevel TCP/IP
1. Computer name: device’s name of type VIVID_I-00nnnn or
ECHOPAC7-00nnnn, where “nnnn” is the system’s serial number. Do not
change the computer name.
2. IP settings: system IP settings
3. Remote archive setup: remote archive IP address and name (EchoPAC PC
or EchoServer)
4. Save TCP/IP settings. The changes will be effective after the system is
rebooted.
5. Advanced DICOM log: creates a detailed DICOM related report log. Should
be used only if DICOM issues are registred (see page 341 about report log
generation).
To Next Page
Loading...
