Niro Soavi S.p.A
4c091e0c.doc 4.9.7
ATTENTION: If the pressure level is too high the circuit may be damaged,
particularly during cold starts: oil viscosity problems can lead to damage
in the delivery oil filter and motor overload triggering the electric
protection devices. When adjusting pressure you need to take into
account ambient conditions and the temperature of cooling water.
OIL CHANGE
The frequency of oil change intervals is given in the "Tables for Regular
Servicing" at Chapter 4.2.
Use only oil as specified in Table 4.9.1.
To change the oil (see figure 4.9.1):
- - prepare a reservoir to collect the oil, and of a size that is suitable to
contain the amount of oil found in the machine according to table 4.9.2;
- open the filling tap on the crankase cover
- open the drain valve and the plug (J) and let the oil drain out.
- once the oil has drained out completely, close the tap and the plug (J), and
pour in the new oil through the filler plug
- check the oil level through the sightglass.
CAUTION: Used oils are extremely harmful to environment and should be
disposed of correctly, in accordance with the local regulations.
To Next Page