Niro Soavi S.p.A
2.8.7 ELECTRICAL CONNECTIONS
The power line to the control board should be of appropriate type according to
the length, type of routing, ambient temperature, nature of the load, and always
in accordance with the provisions of the local regulations on this matter.
If no specific agreements have been made in writing with NIRO-SOAVI, the
user shall be responsible for establishing the features of the power line and
earthing conductor up to the terminal board of the machine, as well as selecting
appropriate protection devices against short-circuits and contact voltage.
Where the electric board is supplied by NIRO SOAVI we will provide a list of
cables with size calculated assuming a length of 50 meters, closed conduit with
three-pole cables and 40 °C ambient temperature.
As far as the power details of the machine and wiring diagrams, reference
should be made to the electric specifications and diagrams shown in Section 1 -
TECHNICAL SPECIFICATIONS and in Section 6 – WIRING DIAGRAM.
CAUTION: The indications given concerning the wiring refer to standard
laying and environmental conditions; the values shown are purely
indicative, therefore they should ALWAYS be cross-checked by the user
depending on the actual operating conditions.
The electric connections between machine and electric power board and
between electric power board and power mains must be made by the Customer
who is also responsible for checking that they have been properly executed and
that they comply with the wiring diagram, before the machine is started up.
NIRO SOAVI shall not be liable for injury to people or damage to objects
caused by incorrect connection of electric equipment; all electric connection
must be checked by authorized personnel.
If in doubt please contact NIRO SOAVI.
2C001E0C.DOC 2.8.10
To Next Page
Loading...
