Niro Soavi S.p.A
2.8.2 ACCESS TO THE INSIDE OF THE MACHINE
The machine is provided with a satin-finish stainless steel fairing for:
- protection of the internal components from dirt, water or fouling with product;
- easy cleaning of the external parts;
- operator's protection from moving, under voltage or hot parts which may be
hazardous for the personnel, in compliance with EC standards and CE mark
requirements, and safety regulations in force in the country where the
machine is installed.
CAUTION: to avoid any danger of injuries to the operators, the machine
should be operated ONLY with the panneling in place or protections
completely closed.
Panels may be removed to allow maintenance and/or installation work to be
carried out.
Side panels are fitted with handles and special key locks to access the inside of
the machine.
WARNING: To prevent accidents, ensure that ALL retainers are
tightened?? before starting the machine; to remove or replace panels
always use the handles provided. Depending on the size of the panels,
two persons might be needed to remove or instal the panels.
CAUTION: Before removing the protection panels, the installation/
maintenance personnel should cut off the power input to the machine by
locking the appropriate power switch with a padlock.
2C001E0C.DOC 2.8.2
To Next Page
Loading...
