Niro Soavi S.p.A
2.1.3 USE OF THE MACHINE IN DANGEROUS ZONES
Use of the machine in dangerous zones is allowed only if the machine has been
designed specifically for use in such conditions using suitably certified
components.
Identification and classification of danger zones is the responsibility of the
customer who is required to specify them.
The factory electric system as well as ground and unipotential connections
must be designed so as to prevent any danger of explosion.
Where equipment for the detection of dangerous gas, liquids or vapors is used it
must installed by the user; the same applies to systems for ventilation and
exhaust of smoke and vapor from the danger zone.
All personnel must be aware of the potential hazards present in the danger
zone and connected with the use of dangerous products for the safety of
persons and of the environment.
Any tools and equipment used inside danger zones must be suitable for use in
these conditions; the user of the machine is responsible for selecting them and
making them available as well as for the way they are used.
It is extremely important to regularly check belt tension in order to prevent
dangerous overload or overheating as this could create a risk of fire or
explosion.
2C001E0C.DOC 2.1.3
To Next Page
Loading...
