VLT
®
5000 Series
Not ready for operation (UNIT NOT READY):
The drive is in Fieldbus profile mode (parameter
512). The drive is not ready for operation as bit 00,
01 or 02 in the control word is "0", the drive has
tripped or there is no mains supply (only seen on
units with 24 V DC supply).
Ready for operation (CONTROL READY) :
The drive is ready for operation. For extended units
supplied with a 24 V DC supply the message also
comes up when there is not mains supply.
Bus jog, remote controlled (REM/RUN BUS
JOG1):
Remote control has been selected in parameter 002
and the Fieldbus has been selected in parameter
512. Bus Jog has been selected by the fieldbus or
serial bus.
Bus jog, remote controlled (REM/RUN BUS
JOG2):
Remote control has been selected in parameter 002
and Fieldbus has been selected in parameter 512.
Bus Jog has been selected by the fieldbus or serial
bus.
MG.51.A1.02 - VLT is a registered Danfoss trade mark
174
To Next Page
Loading...
