Niro Soavi S.p.A
2.8.6 POSITIONING THE ELECTRIC EQUIPMENT
Our machines are supplied in the standard version without electric power board;
this will be designed and constructed according to the specifications of the
machine as an optional; in any case the machine is fitted with a terminal box
which houses all the connections of the electric devices installed in the
machine, excluding the motors.
Where the electric board is supplied, and as a general recommendation, the
cabinet containing the electric control and power equipment - if not built in the
machine - should be placed as far as possible in clean, dry, ventilated premises
which should be free from vapour, suspended dust or corrosive release. Before
ordering the machine, the Customer should make sure that the intended place
of installation is suitable to protect the equipment from any aggression.
Besides, it should be ascertained that no heat sources are present in the vicinity
to avoid local overheating and ensure that all electric equipment can be cooled
down efficiently.
When forced ventilation is provided, any air vent should remain unobstructed. If
it has been established that the ambient air is not suitable for proper ventilation,
an air duct should be provided, in addition to selecting a control board suitable
for the particular operating conditions existing locally.
For the type, overall size, weight and installation requirements of the control
board, see Section 1 TECHNICAL SPECIFICATIONS (if the board has been
supplied by NIRO-SOAVI).
2C001E0C.DOC 2.8.9
To Next Page
Loading...
