Niro Soavi S.p.A
2.1.1 SAFETY INFORMATION
Although this machine has been designed to prevent all risks for operators the
possibility of risk for both personnel and materials or equipment is not excluded;
the general safety instructions and norms for operators and objects must be
observed scrupulously, taking every precaution to prevent accidents.
The machine must be used only if its state of preservation, operation and repair
is perfect and in compliance with what is required and specified in this manual.
Use of this machine is permitted only for the purposes for which it was
constructed and tested; use of the machine for purposes other that the ones
mentioned or beyond specified use limits shall relieve the manufacturer of all
responsibility in case of damage to persons or things and invalidate the
warranty.
Failure to service the machine according to the instructions provided in this
manual, or use of non-original spare parts, may lead to risks for the personnel
operating the machine.
2.1.2 PERSONNEL SAFETY
The machine must be used only by personnel members who are familiar with
the INSTRUCTIONS FOR USE AND MAINTENANCE and with the specific
technical information required to carry out their tasks, using suitable tools and
equipment; only authorized personnel are allowed to access, operate or service
the machine.
All members of personnel must wear clothes that are suitable to prevent
accidents due to clothing getting caught in moving machine parts or to contact
with sharp or pointed parts or with high temperatures.
Protection clothes, safety goggles and safety boots must be worn at all times.
We also recommend the use of personal protection devices to protect operators
from the noise that may be produced by the machine.
Operators must be familiar with the use of the equipment required to carry out
routine and extraordinary maintenance work.
In particular, these instructions must be read by all members of personnel who
may be operating or interacting with the machine, such as:
- Personnel in charge of transportation and handling the machine
- Personnel in charge of connecting the machine to supply mains
- The operator who is to use the machine
- Personnel in charge of servicing the machine
- Personnel who are to carry out machine tests and to check the
characteristics of the product treated.
2C001E0C.DOC 2.1.2
To Next Page