Niro Soavi S.p.A
2.9. SPECIAL NOTES
2.9.1 CONTROL BOARD TO BE PROVIDED BY THE CUSTOMER
If the electric power and control board (optional) is not supplied with the
machine, NIRO-SOAVI will include a Technical Sheet (Section 1 - TECHNICAL
SPECIFICATIONS) showing the electrical requirements of the machine,
together with an operation sequence to enable the Customer to establish the
elements of the control board and the operating features of the required
protection devices for a correct execution and the selection of appropriate
control and protection devices.
CAUTION: NIRO-SOAVI shall not be held liable for damages caused to
either persons or the machine due to mistakes made in the design and/or
execution of the control board.
CAUTION: The control board should be built in accordance with the local
operational and safety regulations in force.
2.9.2 ELECTRIC MOTOR SUPPLIED BY THE CUSTOMER
The electric motor shall be made in accordance with the general specifications
laid down by NIRO-SOAVI as to POWER, NUMBER OF POLES, SIZE,
SERVICE (Section 1 - TECHNICAL SPECIFICATIONS).
The motor shall be placed either on the supporting plate and secured by bolts in
the holes provided (or made at the time of installation) taking care that the
motive pulley is in line with the flywheel.
For information on installation and tensioning of V-belts see Section 3 -
MAINTENANCE.
2C001E0C.DOC 2.9.1
To Next Page
Loading...
