Niro Soavi S.p.A
2.11. CLEANING THE MACHINE
The machine is supplied with external paneling in glazed stainless steel plate
(ARIETE version) which is easy to clean with water.
Washing prevents the deposit of product residuals on the machine: wash the
bodywork with running water from time to time, paying particular attention to the
compression head and the sump.
If required you may use a cloth and any standard mild detergent.
To prevent water from entering the machine, place a suitable covering over the
ventilation hole; do not wet the electric panel or the control panel.
The HERCULES industrial version is supplied without external paneling, but
only with protection panels to cover moving parts: in this case make sure you do
not wet unnecessarily the electrical components of the machine.
WARNING: Before washing with running water, make sure that power has
been cut off by means of the sectioning switch of the supply line that
should be locked with appropriate padlock.
2C001E0C.DOC 2.11.1
To Next Page
Loading...
