Niro Soavi S.p.A
2.7. STORAGE
2.7.1 STORAGE BEFORE INSTALLATION
During the time preceding installation, the machine and its apparatus should be
conveniently stored in closed, clean premises to avoid deterioration and
preserve its efficiency.
If no storage place can be provided other than outdoor, a waterproof cover
should be provided to prevent contact with dust, humidity, rain, etc.
Special attention should be given to electric control boards and electronic
equipment, which are easily affected by humidity and low temperature.
If separate from the machine, they should be stored indoors and provided with
special humidity absorbers.
WARNING: Storage temperature should not be less than -5°C and more
than +55°C; humidity should be less than 95%, with no-condensate.
Vibrations should be avoided as much as possible.
2.7.2 STORAGE FOR PERIODS LONGER THAN 3 MONTHS
If the machine is expected to remain stored for over three months before
installation, provide a closed storage place protected from bad weather, dust or
corrosive releases, as described before. Observe the above precautions for
electric components.
In addition YOU MUST:
- loosen the tension of V-Belts using the appropriate tighteners (sees Section 3
- MAINTENANCE);
- disassemble the plungers and seal packings (see Section 3 -
MAINTENANCE)
WARNING: Pistons and seal packings should be reassembled, and belts
tensioned at the time of machine installation.
WARNING: In case the machine plungers are chrome coated, or are using
a tungsten carbide detonated coating (see Section 1 – TECHNICAL
SPECIFICATIONS), they must be disassembled together with the packings
if the machine is in storage more than ONE month.
2C001E0C.DOC 2.7.1
To Next Page
Loading...
