VLT
®
5000 Series
Mechanical installation ...................................................41
Menu mode
.................................................................75
Menu structure
.............................................................78
Motor thermal protection
................................................59
N
Normal/high overload Torque control,open loop................102
P
Parallel coupling of motors.............................................63
Parameter selection
.................................................75, 75
Parameter Setup
..........................................................
74
PID for process control
..................................................97
PID for speed control
....................................................
98
Potentiometer reference
.................................................68
Programming of Torque limit and stop
............................
103
Pulse start/stop
............................................................68
Q
Quick discharge
...........................................................99
Quick Setup via Quick menu
...........................................75
R
Read out and programming of indexed parameters.............77
Relay outputs:
.........................................................11, 11
RFI switch
...................................................................60
S
Safety earthing:............................................................59
Safety regulations
...........................................................4
Selection of brake resistor
..............................................84
Setting of parameters
....................................................79
Setup change
..............................................................68
Shift between local and remote control
.............................83
Status messages
........................................................172
Structure for the Quick menu mode versusthe Menu mode
..74
Switches 1-4
................................................................66
T
Tightening-up torques and screw sizes.............................59
Torque characteristics:
.................................................8, 8
Two-wire transmitter
......................................................69
U
Use of EMC-correct cables.............................................57
V
VLT 5000 Series protection: ......................................13, 13
Vlt output data (u, v, w):
...............................................8, 8
W
Warning against unintended start......................................4
Warning word 1, Extended status wordandAlarm word
......182
Warnings
...................................................................177
MG.51.A1.02 - VLT is a registered Danfoss trade mark
197
To Next Page