Gehl RT210 - Page 194

Troubleshooting
50940411/G0219 184 Printed in U.S.A.
523613-0
Rail pressure error
Rail pressure: fuel pressure in rail below target range
dependant on engine speed; rail pressure disrupted,
positive governor deviation; maximum positive rail
pressure deviation exceeded concerning set fuel flow;
power reduction may result
Rail pressure: fuel pressure in rail exceeds target
range dependant on engine speed; rail pressure
disrupted, maximum negative rail pressure deviation
with metering unit on lower limit is exceeded
Rail pressure: fuel pressure in rail exceeds target
range dependant on engine speed; rail pressure
disrupted, leakage detected based on fuel quantity
balance; power reduction may result
Rail pressure: fuel pressure in rail exceeds target
range dependant on engine speed; rail pressure
disrupted, maximum rail pressure exceeded
523613-1
Rail pressure: fuel pressure in rail below target range
dependant on engine speed; minimum rail pressure
exceeded
523613-2 Metering unit error
Rail pressure: fuel pressure in rail exceeds target
range dependant on engine speed; metering unit
setpoint in overrun mode not plausible; power
reduction may result
523615-3
Short-circuit
Current drain above target range; metering unit (fuel
system); short-circuit to battery high/low side; power
reduction may result; power reduction may result
523615-4
Current drain below target range; metering unit (fuel
system); short-circuit to battery high/low side; power
reduction may result
523615-5 Fuel system error
Fuel metering unit: the ECU detects no load or
temperature excess of the ECU component for power
supply of the valve; Metering unit (fuel system); open
load; power reduction may result
523698-11 SCR error Engine shut-off due to supervisory function
523776-9 Timeout error Timeout error; limp mode activated
523895-13
Injector adjustment error
Missing or wrong injector adjustment value
programming (IMA) injector 1 (in firing order)
523896-13
Missing or wrong injector adjustment value
programming (IMA) injector 2 (in firing order)
523897-13
Missing or wrong injector adjustment value
programming (IMA) injector 3 (in firing order)
523898-13
Missing or wrong injector adjustment value
programming (IMA) injector 4 (in firing order)
Table 56: Deutz Engine Error Codes
Error Code Engine Error Code Type Error Description