Getting Started 23
CAUTION: When installing a tool, do not attempt to gain leverage by jamming one
wrench against the carriage while pushing on the other.
11
Tighten the collet nut by pulling the wrenches toward each other with firm, even force.
CAUTION: The collet nut must be tight enough to prevent the tool from loosening
from centrifugal force.
Removing a tool
CAUTION: When removing a tool, do not attempt to gain leverage by jamming one
wrench against the carriage while pushing on the other.
CAUTION: Never strike the tool from the side to remove it. Striking the tool will
damage the spindle motor bearings.
CAUTION: When changing tools, always place protective material such as foam
board or soft cloth under the router motor to protect the tool should it drop out of
the collet nut.
To remove a tool
1
Slew the router motor near the front of the table.
2
Unplug the router motor.
3
Loosen the collet nut using one wrench while holding the router motor shaft firmly
with the other wrench.
4
Remove the collet, nut, and tool.
5
Remove the tool from the collet.
6
To extend collet life, blow out any debris that may be lodged in the collet using
compressed air.
7
Store properly.
To Next Page
Loading...
