52 Sabre Owner’s Guide
Controlling the spindle air on ATC equipped machines
You can turn on or turn off the spindle air from the Sabre control pad.
To control the spindle air
1
Starting at the Status menu, press the down arrow key until you see:
MAIN MENU 2
A: Position control
B: Manual feed
C: Configuration
2
Press B to select the Manual Feed menu. The display reads:
MANUAL FEED
A: Manual feed mode
B: Manual feed rate
C: Spindle Air
3
Press C to select the Spindle Air menu shown below. Press A to change the selection
from Spindle Air on or off.
SPINDLE AIR CONTROL
A: Turn air on or off
4
Press ENTER to accept the change and SHIFT + EXIT or EXIT repeatedly to return to
the Status menu.
To Next Page
Loading...
Need help?
General
