Gerber Sabre - Table Surface Cleaning; Way Cleaning; Y Way Cleaning; Lead Screw Cleaning

Maintenance 55
Table surface cleaning
Use a hand broom to clean the router table surface after each operation, brushing away the
chips from around the router motor and the work table. Use the lint-free cloth to wipe the table
clean.
X way cleaning
The X ways are the shafts located on the beam and under the beam behind the cover on which
the router motor carriage moves.
To clean the X way
1
Clean the X ways by wiping them with a lint-free cloth.
2
Lubricate the X ways with light machine oil.
Y way cleaning
The Y ways are the shafts on which the beam moves. There is one Y way on each side of the
router running the length of the router.
To clean the Y way
1
Clean the Y ways by wiping them with a lint-free cloth.
2
Lubricate the Y ways with light machine oil.
Lead screw cleaning
CAUTION: Do not oil or lubricate the lead screws in any way. LURBRICATING
THE LEAD SCREW WILL CAUSE DAMAGE.