Gerber Sabre User Manual

32 Sabre Owner’s Guide
5
Make sure the tool touches the gage and then press A to complete initialization. The
display reads:
MAIN MENU 1
A: Z init
B: Speeds/Feeds
C: Home
Adjusting the depth
There are two methods of adjusting the depth of initialization. Permanently alter a tool's
initialization value using the Adjust Depth menu, or temporarily adjust the initialization depth
of the current tool path using the Temp Adjust Depth menu.
Adjusting a tool's initialization depth
After initializing a tool to the table, you can permanently adjust its initialization value using the
Adjust Depth menu. Altering the table initialization value affects all tool paths machined with
that tool including tool paths in different jobs. The adjusted depth remains until you re-initialize
the tool.
Note: the ADJ DEPTH speed key on the Sabre control pad now opens the TEMP ADJUST
MENU rather than the ADJUST DEPTH MENU.
To adjust a tool's initialization depth
1
From the Status menu, press the down arrow key until you see:
MAIN MENU 1
A: Z Init
B: Speeds/Feeds
C: Home
2
Press A to select Z Init. The Z Init menu displays.
Z INIT
A: Table Init
B: Material Init
C: Temp Adjust Depth
3
Press A to select Table Init. The system displays the Table Init menu.
TABLE INIT
A: Manual Table Init
C: Adjust Depth
4
Press C to display the Adjust Depth menu.
ADJUST DEPTH
0.000 in
A: Increase
B: Decrease
5
Press A to increase the depth of cut into the material. Press B to decrease the depth and
leave a web. Press ENTER to record the change. The change remains in affect for that
tool until the next initialization.

Gerber Sabre Specifications

General

Brand	Gerber
Model	Sabre
Category	Printer
Language	English