Gerber Sabre - Page 44

36 Sabre Owner’s Guide
9
Press C to perform a Z axis initialization to the mat surface. The display shows:
Z INIT MATERIAL
A: Initialize
10
Initialize the tool to the table mat (the material to be routed) and press A. The display
shows:
MAIN MENU 1
A: Z init
B: Speeds/feeds
C: Home
11
Press ENTER. The display shows:
STATUS
MACHINE: Active
JOB: Ready
Scrolling tool message
The motor turns on. The router plunges quickly to its initialized height, then plunges into the
mat material and begins cutting.