GWN7000 User Manual
Version 1.0.6.28
Refer to below table when creating or editing a DNAT entry:
Table 41: DNAT
Specify a name for the DNAT entry
Check to enable this DNAT entry.
Select the IP version, three options are available: IPv4, IPv6 or Any.
Select a WAN interface or a LAN group for Source Group, or select All.
Select a WAN interface or a LAN group for Destination Group, or select
All. Make sure that destination and source groups are different to avoid
conflict.
Select one of the protocols from dropdown list or All, available options
are: UDP, TCP, TCP/UCP and All.
Set the Source IP address.
Set the Rewrite IP. The source IP address of the data package from the
source group will be updated to this configured IP.
Set the Destination IP address.
Click on icon to schedule a start date for this DNAT entry to be
applied.
Click on icon to schedule an end date for this DNAT entry to end.
Click on icon to schedule a start time for this DNAT entry to be
applied.
Click on icon to schedule an end time for this DNAT entry to end.
Schedule Weekdays List of
Weekdays
Select the days, on which the DNAT entry will be applied, the unselected
days will ignore this rule.
Schedule Days of the Month
Enter the days of the months (separated by space) on which the DNAT
entry will be applied.
Example: 5 10 15
This will be applied only on 5
th
, 10
th
and 15
th
day monthly.
Treat Time Values as UTC
Instead of Local Time
Check to use UTC as time zone for the specified times, instead of using
GWN7000’s local time.
Check to enable NAT Reflection for this DNAT entry to allow the access
of a service via the public IP address from inside the local network.