Grandstream Networks GWN7000 - Table 20: Create Policy Members; Figure 19: Create a New Member

P a g e | 49
GWN7000 User Manual
Version 1.0.6.28
Figure 19: Create a New Member
Table 20: Create Policy Members
Name
Enter the Name for the member.
Interface
Select the interface to which the member points.
Metric
Enter the value of the metric related to the member (default is 1).
Weight
Enter the weight that will be attributed to the member, in case load balancing is
used, this will indicate how much traffic will be routed via this member through the
specified interface. Default value is 1.
Note: By default, GWN7000 router will generate automatically members for each created/configured WAN
interface and VPN client tunnel interface.
After this, users need to create policies which lists the members that will be used by each policy from the
menu Routing → Policy Routing → Policy.
Click on button in order to create a new routing policy then choose the members that would
be listed (included) on the policy.