Before configuring DDNS settings on the GWN7000, make sure first to create and confirm the DDNS
account via supported providers.
Following steps illustrates how to configure the DDNS settings on your GWN7000:
1. Access to GWN7000 web GUI, and navigate to Router→DDNS, and enable DDNS service.
2. Fill in the domain name created with DDNS provider under Domain Name field.
3. Enter your account username and password under Username and Password fields.
4. Specify the WAN interface to which DDNS is applied under Network interface field.
5. (Optional) For advanced configuration, it is also possible log to Syslog and modify the values of
refreshing fields so to check periodically the updated IP address.
DPI
DPI stands for Deep Packet Inspection which is an option that allows the GWN7000 to analyze the core of
the packet to collect and report information at the Application-layer, such as traffic volume of an application
used by the host.
Snort OpenApp ID allows the System Administrator to view the internet traffic of users. The GUI displays
traffic data in a human-readable format, such as 'Streaming MP4 & Netflix - 31% of total traffic usage.' The
data is accompanied by a graph.
GWN7000 is using Snort for packet inspection and displays traffic status under Status→Application
Traffic as shown on the figure below.
To Next Page
Loading...
Need help?
General
