H3C S5120-EI Series - Shutdown

88
Description
Use the reset lacp statistics command to clear the LACP statistics on the specified member ports or all
member ports, if no member ports are specified.
Related commands: display link-aggregation member-port.
Examples
# Clear the LACP statistics on all link aggregation member ports.
<Sysname> reset lacp statistics
shutdown
Syntax
shutdown
undo shutdown
View
Layer 2 aggregate interface view
Default level
2: System level
Parameters
None
Description
Use the shutdown command to shut down the current aggregate interface.
Use the undo shutdown command to bring up the current aggregate interface.
By default, aggregate interfaces are up.
Examples
# Shut down Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] shutdown