H3C S5120-EI Series - Lldp Admin-Status

216
Inventory TLV YES YES
Table 50 Output description
Field Description
LLDP tlv-config of port 1 Advertisable optional TLVs of port 1.
NAME TLV type.
STATUS
Indicates whether TLVs of a specific type are currently sent through a
port.
DEFAULT
Indicates whether TLVs of a specific type are sent through a port by
default.
Basic optional TLV
Basic TLVs:
• Port description TLV
• System name TLV
• System description TLV
• System capabilities TLV
• Management address TLV
IEEE 802.1 extended TLV
IEEE 802.1 organizationally specific TLVs:
• Port VLAN ID TLV
• Port and protocol VLAN ID TLV
• VLAN name TLV
IEEE 802.3 extended TLV
IEEE 802.3 organizationally specific TLVs:
• MAC-Physic TLV
• Power via MDI TLV
• Link aggregation TLV
• Maximum frame size TLV
LLDP-MED extend TLV
LLDP-MED TLVs, including:
• Capabilities TLV.
• Network Policy TLV.
• Extended Power-via-MDI TLV.
• Location Identification TLV.
• Inventory TLV, including hardware revision TLV, firmware revision TLV,
software revision TLV, serial number TLV, manufacturer name TLV,
model name TLV, and asset id TLV.
lldp admin-status
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Layer 2 Ethernet interface view, port group view
Default level
2: System level