H3C S5120-EI Series - Qinq Ethernet-Type

198
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
# Enable basic QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member gigabitethernet 1/0/1 to gigabitethernet
1/0/6
[Sysname-port-group-manual-1] qinq enable
qinq ethernet-type
Syntax
qinq ethernet-type hex-value
undo qinq ethernet-type
View
System view
Default Level
2: System level
Parameters
hex-value: Hexadecimal protocol type value ranging from 0x0001 to 0xFFFF, excluding the common
protocol type values listed in Table 45.
Table 45 Common prot
ocol type values
Protocol type Value
ARP 0x0806
PUP 0x0200
RARP 0x8035
IP 0x0800
IPv6 0x86DD
PPPoE 0x8863/0x8864
MPLS 0x8847/0x8848
IPX/SPX 0x8137
IS-IS 0x8000
LACP 0x8809
802.1x 0x888E
Cluster 0x88A7
Reserved 0xFFFD/0xFFFE/0xFFFF
Description
Use the qinq ethernet-type command to configure the TPID value in VLAN tags.