H3C S5120-EI Series - Raw-Vlan-ID Inbound

201
raw-vlan-id inbound
Syntax
raw-vlan-id inbound { all | vlan-list }
undo raw-vlan-id inbound { all | vlan-list }
View
QinQ view
Default Level
2: System level
Parameters
vlan-list: Specifies one or multiple CVLANs in the format of vlan-list = { vlan-id [ to vlan-id ] }&<1-10>. You
can provide up to 10 VLAN ID lists, by each of which you can specify an individual VLAN ID with the
vlan-id argument, or a VLAN ID range in the format of vlan-id to vlan-id, where the second VLAN ID must
be greater than the first VLAN ID. The vlan-id argument ranges from 1 to 4094.
all: Specifies all VLANs.
Description
Use the raw-vlan-id inbound command to tag frames of the specified CVLANs with the current SVLAN.
Use the undo raw-vlan-id inbound command to remove the configuration.
CAUTION:
• You can run this command in the same view many times. A new configuration does not overwrite the
previous ones and the configured values are automatically sorted in ascending order.
• An inner VLAN tag corresponds to only one outer VLAN tag.
• To change the outer VLAN tag, remove the existing outer tag configuration and configure a new one.
Related commands: qinq vid.
Examples
# Configure GigabitEthernet 1/0/1 to tag frames of VLAN 3, VLAN 5, and VLAN 20 through VLAN
100 with SVLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qinq enable
[Sysname-GigabitEthernet1/0/1] qinq vid 100
[Sysname-GigabitEthernet1/0/1-vid-100] raw-vlan-id inbound 3 5 20 to 100