H3C S5120-EI Series - Protocol-Based VLAN Configuration Commands; Display Protocol-Vlan Interface

160
By default, VLANs are matched based on MAC addresses preferentially.
This command only applies to VLANs based on a single MAC address and IP subnet-based VLANs. If
both the MAC address-based VLAN function and the IP subnet-based VLAN function are created on a
port, MAC address-to-VLAN mappings are matched preferentially, and the left VLAN entries (VLAN
entries based on a single MAC address and IP subnet-based VLANs) are matched as configured by the
vlan precedence command.
Examples
# Configure to match VLANs based on MAC addresses preferentially on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] vlan precedence mac-vlan
Protocol-based VLAN configuration commands
display protocol-vlan interface
Syntax
display protocol-vlan interface { interface-type interface-number1 [ to interface-type interface-number2 ]
| all } [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
2: System level
Parameters
interface-type interface-number1: Specifies an interface by its type and number.
interface-type interface-number1 to interface-type interface-number2: Specifies an interface range.
all: Displays information about protocol-based VLANs on all ports.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256
characters.
Description
Use the display protocol-vlan interface command to display information about protocol-based VLANs
for the specified port(s).
Examples
# Display protocol-based VLAN information on GigabitEthernet 1/0/1.
[Sysname] display protocol-vlan interface gigabitethernet 1/0/1
Interface: GigabitEthernet1/0/1