H3C S5120-EI Series - Port-Group Manual; Reset Counters Interface

35
Use the undo port bridge enable command to disable bridging on the Ethernet interface.
By default, bridging is not enabled on Ethernet interfaces.
If the outgoing interface in the MAC address entry for a packet is the same as the incoming interface
where the packet arrived, the packet is usually dropped. The bridging function enables an Ethernet port
to forward such packets.
Examples
# Enable bridging on Ethernet interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port bridge enable
port-group manual
Syntax
port-group manual port-group-name
undo port-group manual port-group-name
View
System view
Default level
2: System level
Parameters
port-group-name: Specifies a port group name, a string of 1 to 32 characters.
Description
Use the port-group manual command to create a port group and enter port group view.
Use the undo port-group manual command to remove a port group.
By default, no port group exists.
Examples
# Create port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1]
reset counters interface
Syntax
reset counters interface [ interface-type [ interface-number ] ]
View
User view
Default level
2: System level