H3C S5120-EI Series - Shutdown

143
View
User view
Default level
2: System level
Parameters
vlan-interface-id: Specifies a VLAN interface number.
Description
Use the reset counters interface vlan-interface command to clear the statistics on a VLAN interface.
Before collecting the traffic statistics within a specific period of time on an interface, you need to clear the
existing statistics first.
• If the vlan-interface-id argument is not specified, this command clears the statistics of all VLAN
interfaces.
• If the vlan-interface-id argument is specified, this command clears the statistics of the specified
VLAN interface.
Related commands: display interface vlan-interface.
Examples
# Clear the statistics on VLAN-interface 2.
<Sysname> reset counters interface vlan-interface 2
shutdown
Syntax
shutdown
undo shutdown
View
VLAN interface view
Default level
2: System level
Parameters
None
Description
Use the shutdown command to shut down a VLAN interface.
Use the undo shutdown command to bring up a VLAN interface.
By default, a VLAN interface is up except when all ports in the VLAN are down.
You can use the undo shutdown command to bring up a VLAN interface after configuring related
parameters and protocols for the VLAN interface. When a VLAN interface fails, you can shut down the
interface with the shutdown command and then bring it up with the undo shutdown command. In this
way, the interface may resume.
The state of any Ethernet port in a VLAN is independent of the VLAN interface state.