H3C S5120-EI Series - Lacp System-Priority; Link-Aggregation Lacp Traffic-Redirect-Notification Enable

82
Description
Use the lacp period short command to set the LACP timeout interval on a port to the short timeout interval
(1 secon d) .
Use the undo lacp period command to restore the default.
The default LACP timeout interval is the long timeout interval (30 seconds).
Examples
# Set the LACP timeout interval on port GigabitEthernet 1/0/1 to the short timeout interval (1 second).
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] lacp period short
lacp system-priority
Syntax
lacp system-priority system-priority
undo lacp system-priority
View
System view
Default level
2: System level
Parameters
system-priority: Specifies the LACP priority of the local system, ranging from 0 to 65535. The smaller the
value, the higher the system LACP priority.
Description
Use the lacp system-priority command to set the LACP priority of the local system.
Use the undo lacp system-priority command to restore the default.
By default, the system LACP priority is 32768.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation lacp traffic-redirect-notification enable
Syntax
link-aggregation lacp traffic-redirect-notification enable
undo link-aggregation lacp traffic-redirect-notification enable
View
System view