H3C S5120-EI Series - Region-Name; Reset Stp

109
[Sysname-mst-region] instance 1 vlan 2
region-name
Syntax
region-name name
undo region-name
View
MST region view
Default level
2: System level
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Description
Use the region-name command to configure the MST region name.
Use the undo region-name command to restore the default MST region name.
By default, the MST region name of a switch is its MAC address.
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a switch
jointly determine the switch's MST region.
After configuring this command, run the active region-configuration command to activate the configured
MST region name.
Related commands: instance, revision-level, vlan-mapping modulo, display stp region-configuration,
check region-configuration, and active region-configuration.
Examples
# Set the MST region name of the switch to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
reset stp
Syntax
reset stp [ interface interface-list ]
View
User view
Default level
1: Monitor level
Parameters
interface interface-list: Clears the MSTP statistics of the ports specified in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
indicates that you can specify up to 10 ports or port ranges.