EasyManuals Logo

H3C S5120-EI Series Command Reference

H3C S5120-EI Series
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
2
NOTE:
• If you set different broadcast suppression thresholds in Ethernet interface view or port-group view
multiple times, the one configured last takes effect.
• For a particular type of traffic, confi
g
ure either storm suppression or storm control, but not both. If both
of them are configured, you may fail to achieve the expected storm control effect.
Examples
# Set the broadcast suppression threshold to 20% on Ethernet interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] broadcast-suppression 20
# Set the broadcast suppression threshold to 20% on all ports in manual port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/2
[Sysname-port-group-manual-group1] broadcast-suppression 20
description
Syntax
description text
undo description
View
Ethernet interface view
Default level
2: System level
Parameters
text: Creates an interface description, a string of 1 to 80 characters. Valid characters and symbols
include English letters (A to Z, a to z), digits (0 to 9), special English characters, spaces, and other
Unicode characters and symbols.
NOTE:
• Each Unicode character takes the space of two regular characters.
• To use a type of Unicode characters or symbols in an interface description, install the specific input
method editor and lo
g
in to the device throu
g
h remote lo
g
in software that supports this character type.
• When the length of a description string reaches or exceeds the maximum line width on the terminal
software, the software starts a new line, possibly breaking a Unicode character into two. As a result,
garbled characters may be displayed at the end of a line.
Description
Use the description command to change the description of the current interface.
Use the undo description command to restore the default.

Table of Contents

Other manuals for H3C S5120-EI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5120-EI Series and is the answer not in the manual?

H3C S5120-EI Series Specifications

General IconGeneral
BrandH3C
ModelS5120-EI Series
CategorySwitch
LanguageEnglish

Related product manuals