H3C S5120-EI Series - Interface; Jumboframe Enable

23
View
Port group view
Default level
2: System level
Parameters
interface-list: Specifies a Ethernet interface list, in the format of interface-type interface-number [ to
interface-type interface-number ] &<1-10>, where &<1-10> indicates that you can specify up to 10 ports
or port ranges.
Description
Use the group-member command to assign Ethernet interfaces to a port group.
Use the undo group-member command to remove Ethernet interfaces from the port group.
By default, a port group does not contain any member ports.
Examples
# Assign Ethernet interface GigabitEthernet 1/0/1 to port group group1.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group-manual-group1] group-member gigabitethernet 1/0/1
interface
Syntax
interface interface-type interface-number
View
System view
Default level
2: System level
Parameters
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Description
Use the interface command to enter interface view.
Examples
# Enter GigabitEthernet 1/0/1 interface view.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1]
jumboframe enable
Syntax
jumboframe enable